The E580 emulates the classic sounds of digital, BBD (bucket brigade), and tape-based delays with four parameters under voltage control. This 14hp wide Eurorack module accepts either +/-12V standard power or +/-15V MOTM/power. Using a 40MHz DSP and 24-bit codec, the E580 recreates the pitch-shift modulation of BBDs, including the variable bandwidth and noise floor, without costly and scarce BBD ICs. In Tape Mode, wow & flutter, tape saturation and non-linear distortions emulate classic tape units without the bulk and maintenance. There are two simultaneous audio outputs: a straight delay and a variable tapped delay. The tap position is a percentage of the main delay time. This allows very short delays (<350μs) as well as long delays (750ms). Both tap position offset and main delay time are voltage-controlled over a -5v to +5v range.
Feedback is jumper-selectable from either the tapped position or the main delay. This flexibility can generate standard rhythmic delays (feedback from main delay) or a series of pre-delay reflections (tapped delay) which sound very different from each other.
|Power||14-pin Eurorack (90mA from +12V, 20mA from -12V)
4-pin MOTM (90mA from +15V, 20mA from -15V)
|CV input range||10Vpp (-5V to +5V), DC to 8KHz|
|Audio Input||10Vpp (-5V to +5V), 18KHz bandwidth (in Clean mode)|
|Audio Output||10Vpp (-5V to +5V), 5Hz to 18KHz|
|Delay Time||Maximum of 780ms (0.78 seconds)|
|Jumper Options||JP2: feedback will be taken from the Tap output (position 1-2) or the Delay output (position 2-3)|
|Wet/Dry||Sets the effects mix|
|Feedback||Applies negative feedback (CCW) or positive feedback (CW). When placed in the center, there is zero feedback.|
|Tap Offset||Sets the percentage of the Tap Out in relation to the Delay Time. For example, if the Delay Time is set to 100ms, the Tap is set from 0-100ms. The time resolution is very fine (over 7,000 independent positions) to allows very smooth modulation of the Tap position.|
|Delay Time||Sets the delay time for the Delay Out. Note that since Tap Out is a percentage of Delay Time, if you change the Delay Time there is a corresponding change to the Tap Out delay time. The time ratio of Delay to Tap is constant however.|
|Mode switch||Choose from one of three delay types|
INPUTS AND OUTPUTS
|Audio In||Signal input, can be line level or modular synth level|
|Delay Out||Delayed signal output|
|Tap Out||Delayed output modified by Tap Offset value|
|Delay input||CV input for modulating the Delay Time value|
|Mix input||CV input for modulating the Wet/Dry value|
|Feedback input||CV input for modulating the Feedback value|
|Offset input||CV input for modulating the Tap Offset value|
Paiement et sécurité
Vos informations de paiement sont gérées de manière sécurisée. Nous ne stockons ni ne pouvons récupérer votre numéro de carte bancaire.